BME688 Environmental Sensor with AI Function, Supports Temperature/Humidity/Barometric Pressure/Gas Detection, I2C and SPI, Support Raspberry Pi/Raspberry Pi Pico/Arduino / ESP32,etc.

Overview
BME688 Environmental Sensor with AI Operate, measure Barometric strain, Environmental temperature, Relative humidity, VOC and VSC gasoline change detection (helps IAQ calculation together with the software program bundle, and built-in AI perform).
The BME688 is 4-in-1 environmental sensor that mix barometric strain, ambient temperature, relative humidity, and gasoline measurement in a single small bundle. They’ll detect a variety of gases, together with unstable natural compounds (VOCs), and are used for air high quality monitoring in good houses, aiming to enhance folks’s well being.

Options
Onboard BME688 sensor to measure temperature, humidity, barometric strain, and gasoline
Helps I2C communication, I2C tackle configurable, with I2C bus cascading help
Helps SPI communication, enabled through CS pin (I2C bus by default)
Onboard voltage translator, suitable with 3.3V/5V degree
Comes with on-line improvement assets and handbook (examples for Raspberry Pi / Raspberry Pi Pico / Arduino / ESP32)

Specification
Communication interfaces : I2C and SPI
Dimensions : 27 × 20mm

Temperature sensing
Temperature sensing : vary -40~85°C
accuracy : ±0.5℃ (0~65℃)

Humidity sensing
vary : 0~100percentRH
accuracy : ±3percentRH

Barometric strain sensing
vary : 300~1100 hPa
accuracy :±0.6hPa (0~65℃)

Fuel sensing: helps VOC and VSC gasoline change detection

On-line Growth Sources /Consumer Manuall://bit.ly/3FDldKK

PACKAGE CONTENT
BME688 Environmental Sensor x1
PH2.0 6PIN cable (~20cm) x1

BME688 Environmental Sensor with AI perform, measure Barometric strain, Environmental temperature, Relative humidity, VOC and VSC gasoline change detection (helps IAQ calculation together with the software program bundle, and built-in AI perform)
Helps I2C communication, I2C tackle configurable, with I2C bus cascading help
Helps SPI communication, enabled through CS pin (I2C bus by default)
Onboard voltage translator, suitable with 3.3V/5V degree
Comes with on-line improvement assets and handbook (examples for Raspberry Pi / Raspberry Pi Pico / Arduino / ESP32)