This can be a low profile angled digicam mount that’s appropriate with the Unifi sequence of bullet cameras, together with the G3, G4, G5, G6 (all Bullet and Professional variants), and AI.
The mounting base includes a 40 diploma bend which helps angle the digicam when mounting below surfaces corresponding to soffits and ceilings.
The mount is designed for the cable to come back by the mounting floor and be completely hidden, however there are additionally three paths offered to route the cable in by the aspect of the mount (drilling required).
The 2 units of mounting holes are to accommodate each the older and newer type base plates that include the Unifi bullet cameras (G3 Bullets had a distinct gap spacing than the brand new G5 Bullets).
These mounts are heavy responsibility and use thick impression resistant plastic. Chrome steel screws are offered for attaching the digicam base and attaching the plastic mount to your floor. If you’re attaching to drywall or masonry then you have to to provide plastic wall anchors.
These are 3D printed ASA components which we make in-house (so you may anticipate some small aesthetic imperfections). ASA is an outside plastic with wonderful climate and UV resistance (in contrast to many different plastics getting used for 3D printing). ASA additionally accepts paint properly, which will likely be helpful for those who plan to color these to match your own home colours. We propose utilizing a twig paint primer earlier than portray.
Works with all Ubiquiti Unifi Bullet cameras (G3, G4, G5, G6, AI, and Professional variants)
Supplies 40 levels of angle to assist in sure mounting conditions & prevents pinching of ethernet cable
3D Printed from sturdy, climate & UV resistant ASA plastic
Chrome steel screws included
Should be used with the mounting base that comes with the Unifi Bullet cameras
Designed and manufactured within the USA
Digicam and digicam mounting plate NOT included
